bitvec::order

Function verify_for_type

Source
pub fn verify_for_type<R, O>(verbose: bool)
where R: BitRegister, O: BitOrder,
Expand description

§Single-Type BitOrder Verification

This function checks some BitOrder implementation’s behavior on only one BitRegister type. It can be used when a program knows that it will only use a limited set of storage types and does not need to check against all of them.

You should prefer to use verify, as bitvec has no means of preventing the use of a BitRegister storage type that your BitOrder implementation does not satisfy.

§Type Parameters

  • O: The BitOrder implementation being tested.
  • R: The BitRegister type for which O is being tested.

§Parameters

  • verbose: Controls whether the test should print diagnostic information to standard output. If this is false, then the test only prints a message on failure; if it is true, then it emits a message for every test it executes.

§Panics

This panics when it detects a violation of the BitOrder rules. If it returns normally, then the implementation is correct for the given R type.